Finish Carpentry Subcontractors in Orlando (Orange, Seminole, Osceola & Lake Counties), FL

Most commercial jobs split this: the architectural millwork sub or shop fabricates casework, paneling, and specialty millwork, and the finish carpenter installs it on site. Trim, base, and crown are often furnished and installed by the finish carpenter. RFQs should state which categories are furnish-and-install versus install-only. A clean bid lists furnishing assumptions per category so the GC can reconcile.

Door leaves, frames, and hardware are typically furnished by a single doors-and-hardware supplier under Division 08 and installed by the finish carpenter. The carpenter receives the schedule, verifies hardware against the drawings, and hangs the doors. RFQs should state who supplies versus installs each component. Bids should list door, frame, and hardware install as separate or combined lines so the GC can match the supply package.

Usually no on commercial jobs. Stain-grade and clear-finished millwork is typically shop-finished by the millwork supplier; paint-grade trim is finished by the painter after the carpenter installs it. The finish carpenter is responsible for installation tolerances and back-priming where the spec calls for it. RFQs should call out which trade carries field finishing if any; bids should state the assumption.

Casework anchoring is typically carried by the finish carpenter — blocking in the wall (when called out as carpenter scope), scribing to the wall, leveling, and fastening to studs or blocking. It's usually priced per each cabinet or per linear foot of casework. RFQs should state casework dimensions and the substrate, since block walls and metal stud walls change the anchor approach and the labor count.

The badge reflects what was reviewed: a verified state license earns License Verified — the usual path for a finish carpentry sub — a verified certificate of insurance earns Insurance Verified, and a sub with both reviewed shows both badges.